High-accuracy and high-speed drive system

The positioning unit (X-Y precision linear table) and the cutter unit use ball screws technology for higher accuracy with linear guide mechanism and higher rigidity than in the conventional machines. The drive control system uses up-to-date servomotor controls and a CPU of higher level specification. This compilation of technologies maximize productivity, high processing accuracy and provides high quality standards for cutting, striping depth by the cutter and terminal crimping process.

High-accuracy and high-speed drive system

New design digital crimping press

Standard digital crimping press on all TRD series machines; High rigid frame model crimping press newly design strengthens the mechanics to pursue enhanced quality. The standard automatic crimp height adjustment on all digital crimping presses also enhances the stability of quality standard and covers crimping of up to 3 mm2 class.

New design digital crimping press

Length measuring unit

Maximum wire feed rate was increased to as high as 6 m/s.
The roller pressure can be adjusted by air pressure, allowing quantitative control.

Length measuring unit

Front side clamp

An automatic self-adjustment link type guide according to wire diameter and self centering, eliminating the necessity of nozzle exchange.

Front side clamp

Rear side clamp

Both clamp open system improving grip range with a more precise longer aluminum cast clamp and increase in V shapes with grooved surface.
The delivery distance was reduced for better handling of complete wire between blades and clamps.

Rear side clamp

Lowering crimp position

The lowering position is set vertically and controlled by timing data, speed cycle and air cylinder management in junction with the digital crimping press synchronize mechanism that is fully programmable. This new technology for both the front and rear sides improves the overall crimp quality of the wire and terminal enhancing the stability of crimp position.

Lowering crimp position

Safety cover

The cover opens upward, providing good accessibility.

Safety cover

Ergonomically replacing terminal reels

The lower terminal or upper terminal reel can be use. The lower is placed inside frame of the machine and the rigid upper terminal reel can be adjusted for side feed or end feed terminal reel.
(Design registration No. 1130371 for the semi - built - into lower position removing type terminal reel.)

Upper terminal reel
Lower terminal reel