Model TRD301 Terminating Machine

TRD301WPA / TRD301WPSA

(Four-module seal units seal insertion and both-ends crimping machine)

Single-end seal insertion/Both-ends seal insertion

Single-end seal insertion

3,000 pieces per hour at maximum (Single-end seal insertion and both-ends crimp processing: cutting length of 100 mm)

Both-ends seal insertion

2,800 pieces per hour at maximum (Both-ends seal insertion and crimp processing: cutting length of 100 mm)

TRD301WPA
TRD301WPA
  • Shown machine is equipped with various options.

Newly developed seal insertion unit

Four-module seal unit

Total of 8 different seals, four on each side of the machine and can process both seal insertion simultaneously at any time.
Seals are pre-program can be selected automatically by setting up the operation data.

Seal insertion speed was increased greatly

The speed was increased by 43% as compared to the conventional machine (TRD111WPA). Wire can be supported without being nipped because the wire guide mechanism is controlled by servo-motor drive system. Furthermore, the operation speed was enhanced greatly.

Stabilized high-speed processing by means of stocking mechanism

The stocking mechanism, which feeds the next seal while the inserting operation is performed in the main body, makes delay of air transport difficult to affect the machine processing speed, and realizes stabilized high-speed processing.

Newly developed seal insertion unit

Figure for seal inserting operation

Figure for seal inserting operation